User manual WHIRLPOOL KRSM 9035 PRODUCT FICHE

[. . . ] Changing programme selection: If the programme selected is changed during drying, the dryer stops. To operate the new programme, again press the “Start (Pause)” button. Interrupting programme: To interrupt a drying cycle, press the “Start (Pause)” button and open the door. Wait at least 5 minutes, to allow the laundry to cool down, before you unload the dryer. [. . . ] Close lint filter and push firmly back into place. Emptying water container: Pull container out by the handle and empty. Replace the container when empty by pushing it completely back into place. If required, activate child safety lock (additional information can be found in the “Door Reversibility/Child Safety Lock” chapter of the instructions for use). Switching dryer off Please note: Only use additives/plastic items specified as dryer safe and rinse items that have been treated with stain remover thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer. 1 Overview of programmes Type of textile Fabrics Programmes / Drying levels Volume of load kg Gentle Options Buzzer Start delay Approximate drying times (in minutes) Very wet load Wet load Ready to wear Cupboard dry * Iron dry * Ready to wear Cupboard dry * Iron dry Multi-layered, thick laundry such as: terry towels, dish cloths and dry towels, bed linen, underwear, terry towelling bath robes. Similar types of laundry which do not require ironing such as: dry towels, bed linen, underwear, baby clothes, T-shirts, cotton socks. Laundry which requires ironing such as: bed and table linen, dry towels, T-shirts, polo shirts, work clothes. Laundry with thick, multi-layered areas such as: bed and table linen, track suits, anoraks, blankets. Laundry which does not require ironing such as: shirts, blouses, T-shirts, sportswear. €¢ If the drying result does not meet your expectation, select a more dry programme. €¢ Is the plug properly inserted into the mains electricity socket?€¢ Is there a power failure?€¢ Has any fluff on the heat exchanger seal been wiped away?€¢ Has any fluff on the door seal been wiped away? • Has the water container been inserted correctly?AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual). Please have the following details ready when calling your After-Sales service representative: • The nature of the fault. • The dryer type and model. €¢ The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. [. . . ] the drying cycle is automatically interrupted. Empty the container and restart the drying programme. Empty the water container after every drying cycle. Delayed Start Delays the start of the drying cycle by 3 to 9 hours. [. . . ]