User manual WHIRLPOOL KSN 7071/A INSTALLATION

[. . . ] • Before replacing the bulb, remove the lamp cover (if present). After the bulb has been replaced, refit the lamp cover. • Internal lights are bayonet bulbs. • The ice and water dispenser light, if present, is a normal screw bulb although some models may have a LED light. [. . . ] Water delivery stops when the lever/button is released. To dispense ice: To obtain ice press against the ice dispenser lever. On models that don't have this lever, press the "Ice" button . Water delivery stops when the lever/button is released. Keep the glass near the water/ice dispenser outlet. To start dispensing, just press lightly against the lever or press and hold the "Water" / "Ice" buttons (in models that don't have a water/ice lever). Pressing hard will not result in faster dispensing or greater quantities. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass (in models with water/ice levers. ) 4. Do not use fragile or easily breakable glasses (in models with water/ice levers). The water dispensed should be consumed within 6 hours. If the water/ice dispenser is only used ccasionally or has been left unused for some time with the appliance switched on, the circuit will need to be cleaned and the first 2 litres of water drawn off and the first ice produced thrown away. Note: For large amounts of ice, enable the "Fast Freezing" function (see the Quick Start guide). If you need a large amount of ice cubes, take them directly from the bucket and not from the dispenser. Important: Turn the ice maker off before removing the ice bucket to stop ice cubes being dispensed accidentally. Use only drinking water for the regular cleaning of the ice maker cover. figure 3 12 STORING, FREEZING AND THAWING FOOD It is important to wrap food so that no water, moisture, or vapour may penetrate; this avoids the transfer of odours and flavours throughout the refrigerator and allows better storage of frozen food. NOTE: Never place warm food in the freezer. Cooling hot foods before freezing saves energy and prolongs the life of the appliance. “MULTIFLOW” AIR SYSTEM (where provided) "MULTIFLOW" is a ventilated airflow system thanks to which the internal temperature is to all intents and purposes uniform. Food can be arranged on any shelf paying attention not to obstruct the air vents, so that air can circulate. GUIDE TO INTERNAL COMPONENTS FRESH CONTROL COMPARTMENT (if installed) The Fresh Control compartment is a container with a tilting movement that facilitates the introduction and removal of food. Opening, removing and replacing the Fresh Control compartment Open the Fresh Control compartment by pressing one of the two buttons at the top (1), while at the same time pulling the compartment as far as it will go. To remove the Fresh Control compartment, follow the instructions above and then lightly rotate and remove the compartment from its seat (2). To replace the compartment, insert the external lateral guides of the container (3a) in their seats near the retaining pins (3b). [. . . ] Rotate the cap counterclockwise to a vertical position and remove the filter from the base grille. Pull the cap and filter cartridge out through the base grille. Remove the cartridge cap by sliding it off the end of the old cartridge. Slide the cartridge cap onto the new cartridge. [. . . ]