User manual WHIRLPOOL KVEE 2536/A -LH PRODUCT FICHE

[. . . ] Same as the last rinse and the final spin in the “Cotton” programme. For improved garment care, spin speed is restricted in these programmes. The wool cycle of this machine has been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash” provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. Min) without “Rapid” with “Rapid” 2:30 — 2:20 1:35 2:05 1:15 1:30 1:10 1:35 1:10 1:20 0:55 0:50 — 0:46 — 1:00 — 0:15 — 0:40 — 0:35 — 4:00 — 3:00*** — 2:30*** — • Particularly suitable for areas with very soft water, washing baby linen and helping people with allergies. [. . . ] Particularly useful if you want to postpone spinning to a later time, or if you want to drain only. The programme stops to “Rinse hold” at the time the “Rinse hold” indicator in the programme flow bar is on. the “Start/ Pause” indicator blinks. : “DOOR OPEN” INDICATOR Before starting and after end of a programme, the indicator lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Reset a running programme before the end”. € • Terminate the “Rinse hold” option • FAILURE INDICATORS If one of the failure indicators blinks, consult the “Troubleshooting Guide” in your Instructions for Use. €Clean pump”: waste water is not pumped out. Spin speed on display blinks: unbalance during spinning. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. respect the manufacturer’s dosing instructions. May prolong the programme by up to 15 minutes. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating “Start delay”. • Select programme , temperature and options. € Press the “Start delay” button to select a delay time up to 23 hours. • Press the “Start/Pause” button . On the display, the start delay symbol and the dot between hours and minutes blink. € The delay time indicator disappears when the programme starts and it is replaced by the remaining programme duration. € Once having pressed the “Start/Pause” button , the delay time can be changed by pressing again the “Start delay” button. to cancel the “Start delay” . [. . . ] The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. SELECT ANY DESIRED OPTION Push the button of any option desired - the indicator lights up. If the combination programme/option or option/option is not possible, the indicator switches off automatically. [. . . ]