User manual WHIRLPOOL KYML8510 INSTRUCTION FOR USE

[. . . ] • The dryer must be earthed as prescribed by law. • Do not use extension leads or multiple adaptors. • Before any maintenance on the dryer disconnect it from the mains supply. • Do not operate the dryer if it has been damaged during transport. [. . . ] General recommendations: Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Do not use inflammable cleansing agents. Do not use the tumble dryer if chemicals have been used for cleaning. Garments treated or contaminated with flammable cleaning sprays or liquids such as petrol, cooking oil or aerosol sprays must not be put in this dryer. Never use and store flammable materials nearby the dryer. • Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. • Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer. • Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • Since lint can go through the filter it is necessary to clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. • Attention rear panel can be hot. 2. • • • • • • • • 3. EC Declaration of Conformity • This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 2006/95/EG Low Voltage Directive • 2004/108/EC Electromagnetic Compatibility Directive • 4. • • • • • • • • • 14 This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. [. . . ] Clean the heat exchanger under running water by turning it around to reach all sides, especially in front and behind. Wipe away dust and lint from the seals and the heat exchanger plates. Remove the lint in the heat exchanger housing. • Has any fluff on the door seal been wiped away? [. . . ]