User manual WHIRLPOOL LAB0050PQ PEDESTRAL INSTALLATION

[. . . ] This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING. You can be killed or seriously injured if you don't immediately follow instructions. [. . . ] Pull the dryer away from the wall enough to loosen the vent clamp. Loosen the clamp and slowly remove the exhaust vent from the dryer exhaust outlet. Pull the dryer away from the wall so the pedestal can be placed in its final location. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. if dryer and pedestal assembly is located in a garage , 6" (15. 2 cm) must be added under pedestal so that the dryer is 18" (46 cm) above garage floor. A separate riser, able to support at least 275 lbs 124. The entire pedestal must sit completely on the riser. Center the two prongs of the bracket on top of the foot. Repeat this step with the other three brackets and feet. Use one bracket on each of the four feet to properly secure the washer/dryer to the pedestal. Excessive Weight Hazard Use two or more people to move and install pedestal. Failure to do so can result in back or other injury. To install a washer/dryer to the pedestal, first thread a locknut onto each foot. Screw each locknut down to the rubber base of the foot. When all 4 locknuts are in place on the feet, screw a foot into each corner brace of the pedestal. Adjust the feet so that the rubber pads extend just below the bottom of the pedestal and keep the pedestal at least ¹/" (3. [. . . ] If it is necessary to adjust the washer/dryer feet to level the unit on the pedestal, the brackets may need to be temporarily loosened. Reach inside the pedestal and use a /" (11 mm) open-ended wrench to loosen the locknut. adjust the washer/dryer feet up or down. [. . . ]