User manual WHIRLPOOL LOE 1007 PRODUCT FICHE

[. . . ] Most favourable programme in terms of combined water and energy consumption for washing cotton laundry. - Reference programme for the Energy Label. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. [. . . ] programme duration (hours : minutes) without “Rapid” with “Rapid” 2:00 2:30 2:00 2:15 1:35 1:20 0:50 0:46 1:00 0:30 0:40 4:00 2:20 2:30 1:35 1:15 1:30 1:14 0:59 - Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference programmes for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. • Turn the programme selector to the desired programme and temperature. • The indication lamp next to the “Start(Pause)” button flashes. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. • Once having pressed the “Start(Pause)” button, the countdown of the time delay begins. When the programme starts, the start delay indicator light goes off and is replaced by the programme sequence indication. • After the “Start(Pause)” button has been pressed, the number of hours preselected can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” . . before you press the “Start(Pause)” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start(Pause)” button: • Press the “Reset” button for at least 3 second - the start delay indicator light goes out. PROGRAMME START Open the tap and press the “Start(Pause)” button. The indication lamp next to the “Start(Pause)” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. [. . . ] The drain hose may be kinked or the filter must be cleaned (see “Cleaning the filter” in your Instructions for Use). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. 1. Turn the programme selector to the “Off/O” position. 3. Open the door and unload the machine. [. . . ]