User manual WHIRLPOOL LOS 610 CITY PRODUCT FICHE

[. . . ] add a stain removing agent in detergent dispenser or chlorine bleach in compartment (depending on model). Particularly stubborn stains can be treated with stain remover before the wash. Dyeing and Bleaching Commercially available products usually consist of a dye colour, fixing agent and salt. Pour the dye colour, the fixing agent and then the salt directly into the empty drum. [. . . ] Dosage Follow the dosage recommendations on the detergent pack. For the water hardness in your area, you can request information from the water company. Soft water requires less detergent than hard water (refer to the water hardness table in the operating instructions). Switch on the washing machine and select the programme Select the desired special options Switch on the appliance Programme end – Unload the laundry Switch off the appliance To switch on the washing machine, press the “On/Off” button. To change the programme once the wash cycle has started, turn the knob to “STOP” and set the new programme. Select an option by pressing the corresponding button. Press the button again to cancel the option. Selecting any option the indication lights up. When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. Open the tap and press the “Start” button. The Start button switches off at the end of the wash cycle. Leave the door ajar to allow the drum to dry out. Black process 45. 0° 150. 0 LPI 50120006GB. fm Page 2 Thursday, July 19, 2007 4:13 PM Programme table Detergent and additives Options Prewash Programme Care Labels Type of wash Load kg Fabric Softener Main Wash Prewash Intensiverinse Max. speed Spin Cotton Cotone bianco 90° Cotone 75°, 60° *, 40°, 30° Averagely to lightly soiled cottons, bed linen, table linen, underwear, towels, shirts, etc. Descaler could contain components that can attack parts of your washing machine. Do not machine wash fabrics that have been treated with solvents or flammable liquids. • The machine is perfectly horizontal with all four feet on ground (see “Installation” in the Instructions Manual). • The transit bolts have been removed. The transit bolts must be removed before the appliance can be used (see “Installation” in the Instructions manual). The appliance has an imbalance detection and correction system. If individual heavy articles are loaded (bathmat, bathrobe, etc. ) this system may reduce the spin speed automatically to protect the appliance or even interrupt the spin cycle altogether, if the imbalance is too great even after several spin starts. • If the laundry is still too wet at the end of the cycle, add smaller articles of laundry and repeat the spin cycle. • Excessive foam formation may also prevent spinning. Ensure correct amount of detergent is used. . . . Detergent and additive product residues in detergent drawer at end of wash: Check whether: . . . Machine vibrates during spin cycle: Check whether: . . . Final spin results are poor: Check whether: AFTER SALES SERVICE If, after carrying out the above checks, the malfunction persists or appears again, turn the appliance off and call our After-Sales Service (see guarantee). Specify: • The nature of the problem • The type and model of washing machine • The service code (the number after the word Service). [. . . ] At the end of the wash cycle the light will turn off. On/Off button This button switches the washing machine on/off. Options Spin speed selector knob Turn the spin speed selector knob to the desired spin speed. If the spin speed “ ” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle. Selecting any option the indication lights up. When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. [. . . ]