User manual WHIRLPOOL LPR 813 INSTALLATION

[. . . ] The last programme selected will light up. Press the button until the desired programme lights up. Load the racks Select a programme Select options If necessary (and if provided) the corresponding indicator lamp lights up. “Change programme in progress” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. Turn on the water tap close the dishwasher door Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). [. . . ] At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Fold down glass holder (A): Depending on the position, for example small or long-stemmed glasses. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. Lower rack: With foldable plate holders (C). Cutlery basket (D): A grid (E) can be fitted onto the cutlery basket to keep items separated. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • Removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • Not removable • Insufficient water softening, calcium deposits. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. (if provided). • Use suitable glasses. • Use suitable cutlery. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). [. . . ] Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! LPR 813 Quick Reference Guide GB On button Off button Programme selection button Start button Switches “on” when the dishwasher is operating. [. . . ]