User manual WHIRLPOOL MAXY 13 PRODUCT FICHE

[. . . ] • Voltage information, power consumption and electrical fusing data are supplied on the front panel behind the door frame. • The appliance must be connected to the mains exclusively by means of a socket with an earth connection in accordance with established regulations. The manufacturer declines all liability for possible damage to property or injury to persons or pets deriving from failure to observe the a/m directions. • Do not use extension leads or multi sockets. [. . . ] Chamber • Liquid chlorine bleach Only add the liquid chlorine bleach up to the “Max” mark. Only use this chamber if the “Bleach” column is shown on the enclosed programme chart. Slide the detergent dispenser in until it clicks shut. Liquid detergentuse front slot Divider insert Powder detergentuse rear slot Divider insert 21 Notes: • Keep detergents and additives in a dry place and out of reach of children. • If you use descaling agents, dyes or bleaches, make sure they are suitable for washing machine use. Descaler could contain components that can attack parts of your washing machine. • Do not use solvents (turpentine, benzine, etc. ) Do not machine wash fabrics that have been treated with solvents or flammable liquids. • Please take care when using stain removers. Many modern stain removers and cleaners are particularly powerful and can chemically attack and damage the plastic components on your washing machine. If you choose to use a prewash stain remover, always apply stain removers to the clothing in an area well away from your washing machine to avoid damage. • You can use liquid detergent in the “Prewash” phase for programmes with this option. In this case put only powder detergents in the compartment for the main wash . Often, however, the faults detected are small enough to be solved in a matter of minutes. For example: The appliance vibrates during the spin cycle. Check whether: • the appliance is levelled and solidly installed on all four feet (see “Installation”); • the transit bolts have been removed. Before using the washing machine you must remove the transit bolts (see “Installation”). The appliance will not start; no lamp lights up. Check whether: • the appliance is plugged in; • the wall socket is functioning correctly (use a table lamp or similar to test); • a programme is selected correctly. Final spin results are poor: The appliance has an imbalance detection and correction system. If individual heavy articles are loaded (bathmat, bathrobe, etc. ) this system may reduce the spin speed automatically to protect the appliance or interrupt the spin cycle altogether if the imbalance is too great after several spin starts. • If the laundry is still too wet at the end of the cycle, add other articles of laundry and repeat the spin cycle. • Excessive foam formation may prevent spinning. Ensure correct amount of detergent is used. • Check whether the spin speed has been reduced to “No spin”. The appliance will not start, but the selected programme lamp is flashing. Check whether: • the appliance door is properly closed (child lock screw); • open the door and close it again. The appliance stops during the programme and the Estimated Remaining Time display is flashing. Check whether: • another programme has been selected. Reselect the desired programme and press the “Start” button, do not add detergent for this programme; • The appliance safety system has been activated. See fault description table. The programme time given on the time remaining display “jumps” suddenly up or down by several minutes, or the programme duration shown at the start increases/decreases by some time: This is a normal adaptation action by the washing machine to factors that can affect the duration of the wash programme, e. g. • excessive foaming; • load imbalance from individual, heavy items of laundry; • longer heating time from correspondingly cold water supply. [. . . ] 2. Loosen the locknut clockwise using the wrench provided. 3. Adjust the height of the foot by hand. 4. Tighten the locknut anti-clockwise to the washing machine. If the appliance is to be installed on a wooden floor, distribute the weight by placing it on a 70 x 80 cm sheet of plywood at least 3 cm in thickness. [. . . ]