User manual WHIRLPOOL MCCD 4920/SW INSTRUCTION FOR USE

[. . . ] Only after the START button has switched off: Press the ON / OFF button. Warning: When the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided depending on the model Upper rack: Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. [. . . ] b A C D Half Load: Load the upper rack (see description of Options). Place the cutlery basket (C), if provided, in the upper rack. Rack height adjustment (also when loaded): Pull the two rack handles (D) outwards and lower the rack. Pull the two rack handles (D) upwards until the rack Upper adjustment: clicks into place (factory setting). Lower adjustment: D Retainer open Retainer closed Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (E) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. E E Lower rack: Depending on the model with fixed or tilting plate holders (F). half Load: Load the lower rack (see description of Options). Greater washing power, particularly for plates and saucepans. f H F Cutlery basket (G): Grid (H) to keep items separate. Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Switches off when the programme starts and indicates the time remaining in hours and minutes. “F Identification of faults for service technician . € On / Off button “Delayed start” button The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time. start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. €œHalf Load” button The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme. The “Half Load” function can be used with programmes marked with an (*). [. . . ] Indicators Add regeneration salt Only add regeneration salt immediately before starting a wash programme. Antibacterial rinse 4) 5) This function adds an antibacterial rinse at the end of the wash cycle, thereby guaranteeing a perfectly clean and sanitized load. The lamp will light up when the function is activated. If the temperature is not maintained during the antibacterial cycle (e. [. . . ]