User manual WHIRLPOOL MD 121/ALU INSTRUCTION FOR USE

[. . . ] €¢ The appliance is designed solely for household use for cooking food products. The manufacturer declines any responsibility for damage due to improper use or wrong control settings. €¢ Any repairs or operations must only be carried out by a qualified technician. €¢ Do not expose the appliance to atmospheric agents. [. . . ] -- Disconnect the appliance from the power supply. Disconnect the appliance from the electrical power supply before carrying out any cleaning operation. €¢ Clean using a cloth moistened with warm soapy water or diluted liquid detergent. €¢ Use safety gloves Stainless steel surface • Clean with a specific commercial product. Cleaning the burners To clean the hob burners, lift them upwards out of their seats (Fig. 1 and 2), then place them in a solution of hot water and nonabrasive detergent for about 10 minutes. After cleaning and washing the burners, carefully dry them. Always make sure that the openings are not blocked. It is advisable to carry out this operation at least once a week or whenever necessary. Make sure to properly refit the burners, turning them slowly so that the four sectors under the burner cap engage the injector holder seat (if perfectly centred, the burner lowers a little and locks in place). 2 Grid maintenance • Clean the grids with a sponge and detergent whenever they are dirty. 1 ENGLISH 51 Insert part R (rawlplug) into holes F and screw hook G into part R (Fig. 4  i Class appliance: 1 Appliance Category  I 2E3B/P (DE) I II 2H3B/P (AT) Type of gas Type of Injector Nominal Nominal Reduced Gas pressure used burner marking heating consumption heat mbar capacity capacity kW kW min. 10 ELECTRICAL POWER SUPPLY: 230 V ~ 50 Hz Total nominal Air necessary (m3) consumption for combustion of 1 m3 of gas 1058 l/h 21. 6 ENGLISH 52 Gas connection For information regarding gas connection instructions, see the injectors table and the “standard” relevant to your country. The gas supply system must comply with current local regulations. The appliance must be connected to the gas supply or gas bottle by means of a rigid copper, steel pipe or rubber hose based on local regulation (see gas connection table). The hose must be connected directly to the outlet connector (Fig. 1), after first of all ensuring you remove any extension cable fitted to your appliance. When the appliance is connected to the gas supply, use soapy water to check for gas leaks. The rubber hose must be connected as shown in Fig. 3, 4 and 5, in compliance with local applicable regulations FOR FRANCE ONLY: do not install the conical fitting (B) supplied on the appliance. [. . . ] €¢ Deliberate or negligent damage, damage caused by failure to observe operating instructions, incorrect installation or by connection to the wrong voltage, damage caused by chemical or electrochemical reaction, rust, corrosion or water damage including but not limited to damage caused by excessive lime in the water supply, damage caused by abnormal environmental conditions. • Consumable parts including batteries and lamps. €¢ Non-functional and decorative parts which do not affect normal use of the appliance, including any scratches and possible color differences. • Accidental damage caused by foreign objects or drainage systems or soap drawers. [. . . ]