User manual WHIRLPOOL MDC 709T MM INSTRUCTION FOR USE

[. . . ] CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS SAFETY ADVICES AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE DRYER REMINDER - MAINTENANCE AND CLEANING DRAINAGE SYSTEM DOOR REVERSIBILITY / CHILD SAFETY LOCK HEAT EXCHANGER TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE PAGE 4 5 7 7 8 9 10 11 PAGE PAGE PAGE PAGE PAGE PAGE PAGE 3 SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. Contact After-Sales Service or your local retailer. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. [. . . ] • Lighters must not be left in pockets. • Never use and store flammable materials nearby the dryer. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • Since lint can go through the filter it is necessary to clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. To minimize the risk of fire in tumble 2. • • • • • • • • 3. • 4. • • • • • • dryer, the following should be observed: • Oil-affected item can ignite spontanously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. If the heat cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard. • Do not tumble dry unwashed items in the tumble dryer. • If it is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated by hair care products be placed in a tumble dryer they should first be washed in hot water with extra detergent - this will reduce, but not eliminate, the hazard. • Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. • Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer. • Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. 5 • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. • Attention rear panel can be hot. EC Declaration of Conformity • This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 2006/95/EG Low Voltage Directive • 2004/108/EC Electromagnetic Compatibility Directive This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] Removing the door lock: Unscrew the 2 screws above and below the door lock system. Lift the door lock from the bottom, sliding it upwards about 1. 5 cm, and remove it. Reverse the door: Fasten the door on the desired side with the 2 screws. Take care to screw in horizontal position to avoid pinching of the seal. [. . . ]