User manual WHIRLPOOL MDE2441AGW MM INSTRUCTION FOR USE

[. . . ] Turn laundry inside out. Preparing laundry Opening door Pull the door handle. Loading dryer Place laundry loosely in the drum to achieve equal drying throughout. Select the drying programme required by turning the programme selector knob (for information, refer to programme table). Select the option required by pressing the corresponding button. The indicator lamp above the relevant button lights up to confirm your selection. [. . . ] Press the button again to cancel the option. The drying programme is started by pressing the “Start (Pause)” button. Changing programme selection: If the programme selected is changed during drying, the dryer stops. To operate the new programme, again press the “Start (Pause)” button. Interrupting programme: To interrupt the dryer during the drying cycle, set the programme selector knob to “ ” and press the “Start (Pause)” button. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the drying cycle stops automatically if you open the door. To restart, after door opening, close the door and press the “Start (Pause)” button again. Warning: Never stop a tumble dryer before the end of the drying cycle, unless all items are quickly removed and spread out so that the heat is dissipated. The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged. Selecting programme Selecting options (if available) Starting dryer Programme end unloading dryer End: Take the laundry out of the dryer. • Are the “ ” and “ ” indicator lamps lighting up?The drying cycle is complete and the laundry can be taken out. • If the drying result does not meet your expectation, select a more dry programme. • Is the plug properly inserted into the mains electricity socket?• Has a drying programme been selected?• Has the “Start (Pause)” button been pressed?• Has the start delay option been selected?• Is the outside vent hose adaptor blocked? The dryer will not operate (after a power failure, always press the “Start (Pause)” button). Lint filter indicator lamp on. AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual). Please have the following details ready when calling your after-sales service representative: • The nature of the fault. [. . . ] • The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. 3 Before using the machine, please also read the instructions for use carefully! MDE2441AGW Quick Reference Guide GB Programme selector knob The drying programme is selected by turning this knob. Programme sequence + “Start (Pause)” button The drying programme is started by pressing this button. The indicator lamp flashes during the selection phase and lights up during drying. Overdry protection Drying Anticrease End of cycle Options Indicator lamps Filter The indicator lamp lights up when the filter needs cleaning. Clean the filter at the end of every cycle. Gentle Reduces drying intensity (recommended for delicate items). Overdry protection The indicator lamp lights up when a humidity controlled program is selected, to indicate the working protection function. Function is not active in time controlled programmes 10’, 20’, 30’, 40’, 60’, 90’ and “ ”. Anti-crease Prevents laundry from creasing up to 12 hours. [. . . ]