User manual WHIRLPOOL MDW 611 AWG PRODUCT FICHE

[. . . ] When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks. To resume the cycle close the door and push Start button again. CANCEL/OFF BUTTON Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute (0:01 is shown into the display). [. . . ] if you want to insert an item): To Cancel the program on running: To change the program in progress: - Open the door with caution (the program pauses) and insert the item/s, (beware of HOT steam!). - Close the door and press the START button again to restart the cycle (the program resumes the cycle from where it was interrupted). - Press the CANCEL/Off button. - (Water drains for up to 1 minute then the appliance switches off). - Press the CANCEL/Off button to cancel the program on running. - (Water drains for up to 1 minute then the appliance switches off). - Press any button except CANCEL/Off button to switch on the appliance. - Press the START button. Switching off the appliance. Everything OK. . . 8 9 After the program is completed appliance turns into Standby mode automatically. Exercise caution when opening the door: beware of hot steam. Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on microfilter NOTE MARK!Unscrew microfilter (1), remove it (2) and remove fine sieve (3). . . Insert Filters Check and clean if necessary Rectifying minor faults yourself. . . 10 Insert and screw on upper and lower arms tightly. . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry Possible causes. . . - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “Delayed start” option). T releasing the door 5 minutes before removing the dishes. ry Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid (see page 3, “Adding rinse aid”). [. . . ] - Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. [. . . ]