User manual WHIRLPOOL MET 9010 AAS INSTRUCTION FOR USE

[. . . ] Only for some models An aesthetic flue can be purchased as an optional accessory. Please check with your After-sales Service to find out whether or not your model. In order to ensure that it is installed in the most suitable way, it is recommended that you only fit the hood after purchasing the flue. Disconnect the power supply at the domestic main switch before carrying out electrical connections. [. . . ] Opening the steam deflector: To open the steam deflector, pull the bottom part (the pins at the centre will disconnect-A), lift the deflector slightly (B) to allow the side pins to come out of their slots (X). To fit and close, proceed in reverse order. Grease filter This should be washed once a month either by hand or in a dishwasher at a low temperature and with short cycle. Cleaning in a dishwasher may cause the metal grease filter to discolour, but this in no way affects its filtering efficiency. Pull the handle downwards and extract the filter. Carbon filter (filter version only) Retains any unpleasant odours produced during cooking. The carbon filter can be washed every two months in hot water and a suitable detergent or in a dishwasher at 65°C (when washing in a dishwasher, run a complete cycle without any dishes). Remove excess water without damaging the filter, then remove the wadding within the plastic frame and put it in the oven at 100°C for 10 minutes to dry it out completely. Replace the wadding every 3 years or whenever it is seen to be damaged. 4 Remove the steam deflector and take out the grease filter. Install the carbon filter behind the grease filter and fasten with two fixing elements. By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. The mains power supply must correspond to the voltage indicated on the appliance rating plate located inside the hood. If provided with a plug, connect the hood to a power socket complying with current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the socket is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Electrical connections Cleaning the hood Important!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. [. . . ] The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Note: always wear work gloves for all installation and maintenance operations. This product has been designed, manufactured and sold in conformity to the following standards: - safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide The hood does not work: • Is the plug properly inserted in the power socket?The hood is not extracting efficiently: • Is the right speed selected? [. . . ]