User manual WHIRLPOOL MET 9050 PAS INSTRUCTION FOR USE

[. . . ] Fix the flue support to the wall as close as possible to the ceiling. For filter hoods, at this stage, also secure the deflector F1 with 2 screws if the flue is provided with top grilles (for flues with bottom grilles, see installation step “7”). Hang the hood on the wall again and fix in place with the screws. For filter versions (flues with bottom grilles), the deflector F2 must be fixed in place of the connector collar (model with fixture with 2 screws) or on the connector collar (model with 2 rear couplings and 1 front fixing screw). [. . . ] Slide the bottom section down into its seat on the top of the hood. Fit the side grilles if provided. 5019 918 01001 GB MET 9010 VAS * Only present on some models 4 3 3 1 2 1. Light : move the switch to the right or press the button to switch on. Extraction speed : move the switch to the right or press the next button to increase extraction speed (or open the electric shutter) . Lamp covers (or halogen lamps, depending on the model). Grease filters: a Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and with a short cycle. Washing in a dishwasher can cause grease filters to b turn white, but this in no way affects efficiency. a. Wash the filter and leave it to dry, proceeding in reverse order to refit it. Bulb/s: Remove the filters and remove the burnt-out bulb. Halogen lamps: Use a small screwdriver or other suitable tool to prise off the cover. Use only max 40 W - E14 bulbs or max 20 W halogen bulbs (depending on the model), taking care not to touch them with your hands. 5019 918 01001 GB MET 9010 VAS Fitting or replacing the carbon filter (filter hoods only). • Do the filters need cleaning or changing?The light does not work: • Does the lamp need replacing?• Is the lamp correctly fitted? • Children must be supervised so that they do not play with the appliance. Do not connect the appliance to the mains power supply until installation has been completed. Always disconnect the hood before any cleaning or maintenance, by unplugging it or turning off the main switch in the home. Do not “flambé” food under the hood. Do not leave pans unattended when frying, since the cooking oil could catch fire. Regular cleaning and maintenance is essential for correct hood operation and good performance. Regularly clean all deposits from dirty surfaces. Regularly remove and clean or change the filter. Do not use flammable materials to duct the extracted air. [. . . ] The discharge air must not be ducted in a flue used for removing fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All national regulations on air discharge must be observed. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. [. . . ]