User manual WHIRLPOOL MRDG 920 UAW INSTRUCTION FOR USE

[. . . ] INSTRUCTIONS FOR USE INSTALLATION INSTRUCTIONS USE AND MAINTENANCE BEFORE USING THE APPLIANCE PRECAUTIONS AND GENERAL ADVICE OVEN ACCESSORIES CLEANING AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE For best use of the oven, carefully read the operating instructions and keep them for future consultation. 4 INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTION This appliance must be earthed by law. Before connecting the appliance to the electrical supply, check that the earth system in your house is working correctly. Check that unit voltage and power, marked on the rating plate applied on the appliance, are correct for the supply. It is necessary that the feeding network is protected by a powerful switch able to disconnect completely the network with a contacts separation of at least 3 mm. [. . . ] 6 Automatic electric ignition of oven and grill burner (depending on the models) The oven door must always be completely open, before the burner ignition To ignite the burner press the knob and turn it clockwise to the maximum position, for the oven burner and anticlockwise to the grill position for the grill burner. Keep it pressed to start up the automatic ignition of the burner. In case there is no electric current, the burner can also be lighted using a match (Fig. It's necessary to keep on pressing the concerned knob for 10 seconds after the ignition (Fig. In this way the safety valve will be started up. If for any reason the burner flame goes out, repeat the procedure as described above. When you will be sure that the burner is on, close softly the oven door. To obtain the desired temperature, turn the knob index to the selected number (Tab. B). OVEN KNOB POSITION 140 170 210 250 TEMPERATURE 140°C 140°C 150°C 160°C 170°C 190°C 210°C 230°C 250°C Second level SURFACE BAKING GRILL (480x240) grill working light Fig. C The grill must be used with the door half-open (see Fig. Fit the deflector S onto the centering pins N on the top of the oven opening (Fig. Then gently close the oven door against the deflector. TAB. 8 B GRILL SURFACE For optimum cooking results, use the surface indicated on the grill, see figure 8 C. USE OF THE TURNSPIT (according to the models) TURNSPIT single For utilization of the turnspit follow the instructions described. 9), paying attention to block it within the two forks F and to balance it in order to avoid any unnecessary effort in motor R. - Put the spit on support G, after having put its opposite end into hole P of motor R. - Place the drip tray with a little water under the spit. - Start up motor R and turn the grill on. - Fit deflector S onto the centering pins N on the top of the oven opening (see Fig. - When removing the spit wear oven mitts. The turnspit can be operated turning the knob clockwise on position , or press the marked button with the symbol . GRILL SURFACE Fig. 9 BEFORE USING THE APPLIANCE • Remove the accessories from the oven and heat it at 200°C for about two hours to eliminate the smell of protective grease and insulating materials. Keep the window open during this operation. [. . . ] • For stubborn grime, use a specific oven cleaning product, following the instructions given on the package. • Clean the outside of the oven with a sponge and lukewarm water. • Do not use abrasive products or steel wool. • Clean the door glass with a liquid detergent. [. . . ]