User manual WHIRLPOOL MSZ 902 DF (EX)/HA INSTALLATION

[. . . ] This manual contains indications and warnings for correct and safe installation of the appliance - read it carefully before starting installation operations. The model you have purchased may differ slightly with respect to some descriptions in this manual, since this manual covers several models. [. . . ] If you sell the appliance give it to the new buyer. Install the appliance in a dry and well-ventilated place. Avoid locations in direct sunlight or near a source of heat (oven, heating, etc. ). If this cannot be avoided, install the appliance respecting the following minimum distances: Coal or paraffin stoves: 30 cm Electric and/or gas stoves:3 cm To allow product handling and sufficient air circulation, leave at least 1 cm clearance at the sides, above the appliance, and between the rear panel and the wall. ELECTRICAL CONNECTION Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the prescriptions. Make sure that the installation and the electrical connection are carried out by a qualified technician according to the manufacturer’s instructions and local safety regulations. 2. Connect the appliance to the mains power supply. 3. Move the refrigerator into its final position. 4. Open both doors and remove the plinth to locate the levelling bolts at the left and right of the refrigerator base. The top bolt (1) will adjust the rear wheel (if provided), and the bottom bolt (2) will adjust the front wheel. 5. Use the wrench provided to adjust the levelling bolts. Turn the levelling bolt clockwise to raise the appliance, or anti-clockwise to lower it. [. . . ] Turn the levelling bolt clockwise to raise the appliance, or anti-clockwise to lower it. It may take several turns of the levelling bolts to adjust the tilt of the refrigerator. [. . . ]