User manual WHIRLPOOL MT 242 WHITE INSTRUCTION FOR USE

[. . . ] textiles made of silk , linen , wool and viscose marked as “handwashable”. This programme (40°C) is tested and approved by the Woolmark Company for handwashable wool. This cycle is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended). If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] Detergents and additives Special Options Temperature Pre- Main Softener Bleach Easy Pre- Intensive Rinse Spin Speed Start wash Wash Ironing wash Rinse Hold Reduction Delay Leicht VorIntensiv SpülStart°C Bügeln wäsche Spülen stopp Schleudern vorwahl Cotton / Hygienic Koch-Buntwäsche Hygiene + 5. Programme Duration (hours : minutes)* 2:05 2:15 2:00 1:30 1:15 1:00 0:45 0:30 0:45 0:35 • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button again. “Spin Speed Reduction” button • Every programme has an automatically allocated maximum spin speed. € Press the button to set another spin speed. € If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. START DELAY The “Start Delay” button allows the user to run the machine at his convenience, for example at night when electricity is cheaper. • Select programme , temperature and options. € Press the “Start Delay” button several times to select the delay time by 1 to 19 hours; • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. € The time delay indication disappears when the programme starts and is replaced by the remaining time. € The number of hours preselected can be reduced later by pressing the “Start Delay” button again. Note: Do not add detergent for this programme. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press again on the “Start/Pause” button. Press the “Start/Pause” button to start the “Drain” programme. prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Close the drum doors and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. [. . . ] The programme sequence and the predefined spin speed indication corresponding to the selected programme lights up. The preselected temperature can be altered by pressing the “+” or “-” button. SELECT THE DESIRED OPTION When you select an option authorized by the programme, the corresponding indicator lights up, except if the combination of programme, additional options and temperature is not possible. €Easy Ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily Mixed” programmes to make ironing easier. [. . . ]