User manual WHIRLPOOL MT 243 BLACK INSTRUCTION FOR USE

[. . . ] textiles made of silk , linen , wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is used in this programme. 5 — ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — Yes Yes Yes Yes Yes Yes — — — — ❉ — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — ❉ ❉ ❉ — — — ❉ — — — — — — — — — ❉ — — ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ 1) ❉ ❉ ❉ 1) ❉ 1) ❉ 2) ❉ ❉ ❉ 1) — 800 1) 20 to 60 1200 1200 30 to 60 20 to 30 Daily Gemengde was 40° Superrapid Snel Delicates Fijne was ❉ — — — — — — ❉ — — — — — — 800 1) 20 to 40 800 1) 20 to 40 400 2) 20 to 30 1200 1200 800 1) — — — — — Wool Wol Handwash Handwas Rinse + Spin Spoelen & Centrifugeren — — — — Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] “Spin Speed” button • Every programme has an automatic predefined maximum spin speed. €¢ Press the button to set another spin speed. €¢ If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme , temperature and options. €¢ Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication next to the “Start Delay” button lights up and goes off when the programme starts. €¢ The time delay indication disappears when the programme starts and it is replaced by the remaining time. €¢ The number of hours preselected can later be reduced pressing again the “Start Delay” button. to cancel the “Start Delay” . Before you press the “Start/Pause” button: • Turn the programme selector to the “Off/0” position. Do not add detergent for this programme. cANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. €¢ Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. whirlpool is a registered trademark of Whirlpool USA Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet. Turn the programme selector knob to the desired programme. [. . . ] unsuitable combinations of options are deselected automatically. €œEasy Ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily” programmes to make ironing easier. €¢ Increases the water quantity and the clothes are spun very soft. €œEco” button • The duration of the wash is extended and the temperature reduced to save up to 40% of energy but maintaining good washing results. [. . . ]