User manual WHIRLPOOL MT 744 / IX INSTRUCTION FOR USE

[. . . ] Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. With this programme you can add starch and/or fabric softener. [. . . ] The programme ends with an intensive spin cycle. in this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme the synthetic, delicate and wool programme and for premature removal of the laundry. 120 110 110 85 75 75 70 65 Rinse hold • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. cleaning the pump filter A regular filter check and eventual cleaning is advisable. Motor smell Washing machine motor creates a typical electrical smell during first cycles, this is normal and disappears after a few cycles. prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the energy label refer to the programme Cotton 60°C. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet. [. . . ] The data on the energy label refer to the programme Cotton 60°C. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet. Set the programme selector to the desired programme. [. . . ]