User manual WHIRLPOOL MTM1911BRGS PRODUCT FICHE

[. . . ] Wait at least two hours before switching the appliance on in order to ensure the refrigerant circuit is fully efficient. Installation of the appliance and electrical connections must be carried out by a qualified electrician, in accordance with the manufacturer's instructions and local safety regulations 4. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. Packing The packaging material is 100% recyclable and carries the recycling symbol. [. . . ] Third step: removing the crisper drawer lid • Slide the crisper drawer lid outwards. • Remove the lid. Crisper drawer Crisper drawer divider Crisper drawer lid 28 63602020GB. fm Page 29 Friday, March 30, 2007 9:18 AM TO REPLACE THE CRISPER DRAWER LID First step: replacing the crisper drawer lid • Insert the back of the lid into the runners. Second step: replacing the crisper drawer divider • Refit the divider in the specific slots located on the bottom of the compartment and crisper drawer wall as shown in the figure. Third step: replacing the crisper drawers • Replace the drawer on the wheels. • Push it back into place. Crisper drawer lid Crisper drawer central divider Crisper drawer FREEZER COMPARTMENT After switching on the appliance, the freezer compartment takes approximately 3 hours to reach a suitable temperature for frozen food storage. The freezer compartment, marked with the symbol , is used for storing frozen food and freezing fresh or cooked food. The inner door of the freezer is especially suitable for storing ice cream or frozen food with a short storage time. Meat (large cuts): thaw in the refrigerator compartment without unwrapping. Before cooking, leave at room temperature for a couple of hours. Meat (small cuts): thaw at room temperature or cook from frozen. Fish: thaw in the refrigerator compartment without unwrapping or cook before fully thawed. Remove the kick plate by pulling forward. Unscrew the bottom hinge fixing screws and remove it. Unscrew the pin of hinge from Hole 1, rotate the bottom hinge 90° and screw the pin to Hole 2. (See Detail A) Then screw the hinge to bottom left side of refrigerator. (FIG-3) Hole 1 Hole 2 Detail-A Bottom hinge and kick plate Figure-3 4. Unscrew the screw fixing the top hinge cover and remove it. Unscrew the two screws fixing the top hinge and remove it. Insert the two big caps that are put in the user manuel bag to left side cap holes. (FIG-4) Insert the two big caps Figure-4 5. Unscrew the screw fixing the top hinge pin. Turn the pin by 180° then fix it to left side of the top hinge by screwing it. [. . . ] When the door is opened, humidity from the room air enters the refrigerator. The more often the door is opened, the faster humidity builds up, especially when the room itself is very humid. • If the room is very humid, it is normal for moisture to build up inside the refrigerator. • It is normal for droplets of water to form on the back wall after the refrigerator self-defrosts. [. . . ]