User manual WHIRLPOOL MYU070EDWG MM INSTRUCTION FOR USE

[. . . ] • Do not use extension leads or multiple adaptors. • Do not use electrical portable outlet devices. • Before any maintenance on the dryer disconnect it from the mains supply. • Do not operate the dryer if it has been damaged during transport. [. . . ] The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. The appliance is not intended for use by young children or infirm persons without supervision. General recommendations: The tumble dryer is intended only for drying textile material washed in water. Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Do not use inflammable cleansing agents. Do not use the tumble dryer if industrial chemicals have been used for cleaning. Garments treated or contaminated with flammable cleaning sprays or liquids such as petrol, cooking oil or aerosol sprays must not be put in this dryer. Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. • Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer. • Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. • Lighters must not be left in pockets. • Never use and store flammable materials nearby the dryer. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • Since lint can go through the filter, it is necessary to clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. [. . . ] Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. C D. Remove the 2 door hinge screws, followed by the door. Unscrew the 2 screws above and below the door lock system. C D F. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. [. . . ]