User manual WHIRLPOOL OBI 9M S INSTRUCTION FOR USE

[. . . ] • Young children should be supervised to ensure they not play with the appliance. • This oven is designed solely for use as a home appliance for cooking food. The manufacturer assumes no responsibility for damage caused by improper or incorrect use. • Any repairs or servicing must be carried out exclusively by a qualified technician. [. . . ] • This appliance must be connected to an a. single phase 230V, 50Hz electricity supply. • The total rated load is 4. 400 kW, connect the appliance accordingly. • Fit an all-pole On/Off switch between the appliance and the power supply with minimum contact separation of 3 mm. Connecting the oven to the power supply • Make sure that the voltage indicated on the rating plate is the same as the mains voltage. The rating plate is on the lower edge of the bottom oven (visible when the door is open). Remove the cover to gain access to the terminal box and insert the power cable (see Fig. Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the cable fastener (see Fig. Put the cover back on by inserting the two blades in the slots. Power supply cable table N° of conductors Type of cable 1N+ ~ H05 RR-F 3 X 2. 5 mm² L Earth (yellow/green) N Fig. 1 5 6gb66031. fm Page 6 Wednesday, April 28, 2004 2:27 PM INSTALLATION This appliance must be correctly installed by a suitable qualified technician strictly in accordance with the manufacturer’s instructions. The manufacturer declines any responsibility for injury or damage to persons or property as a result of improper installation of this appliance. This appliance is designed for building-in to a standard 600mm wide oven housing. The housing, adjacent furniture and all materials used in installation must be able to withstand a minimum temperature of 80°C during periods of operation. In addition, adjacent furniture cabinet doors must be at least 3mm from the appliance at all points. Certain types of vinyl or laminate kitchen furniture cabinetry are particularly prone to heat damage and discolouration. Any delamination or discolouration of materials which occurs below 80°C or where materials are less than 3mm from the appliance will be the liability of the owner. The housing into which the appliance is installed must incorporate a full depth shelf positioned 50mm below the support shelf for the appliance. For building-in to a tall housing, the installation dimensions are as follows: SID EP R E OT CT N IO S Fig. 3 6 6gb66031. fm Page 7 Wednesday, April 28, 2004 2:27 PM Important: When placing the oven in the housing, do not use the oven door as a lever for lifting the oven as damage may result. Lift the oven using the purpose designed metal handles on the sides and slide it into the housing unit. Align the oven centrally in the housing unit before securing it. [. . . ] • Use gloves whenever removing, installing or cleaning the oven door. • Do not immerse the door in water at any time. 3 6gb66031. fm Page 9 Wednesday, April 28, 2004 2:27 PM TROUBLESHOOTING GUIDE Oven not working: Check: • Has the selector knob been set to the required function?Turn off the oven and restart it to see if the fault persists. [. . . ]