User manual WHIRLPOOL OBI D00 S INSTALLATION

[. . . ] 1gb00073. fm Page 2 Wednesday, October 2, 2002 11:41 AM INSTALLING COLUMN/SPLIT LEVEL OVENS Recommendations • Installation must be carried out by a qualified Technician. • After removing the oven from its packaging, place it on the polysterene foam base to protect it from damage. [. . . ] • Identify phase and neutral wires using a voltmeter. Incorrect electrical connections can damage the oven and be dangerous. • The oven power cable must be long enough to connect the appliance built-in to the kitchen units to the electricity supply. • To fulfill the appropriate safety regulations, an allpole disconnect switch with a minimum contact gap of 3 mm must be used for the installation. When connecting with a mains plug this is not necessary, if the plug can be accessed by the user. • Regulations require that the oven is earthed. • Do not use multiple plug adapters or extension cords. • After the oven has been installed, the electrical components must be inaccessible. Preparing the unit Column oven • Kitchen units adjacent to the oven must be heat resistant (80 °C min. ). • Cut the kitchen unit to fit before installing the oven. • Carefully remove any woodchips or sawdust as they could prevent the electrical components from working properly. • Oven dimensions and kitchen unit dimensions are shown in the figures 1-2-3. • To allow for proper ventilation, there must be a ventilation opening at the rear of the unit (as per the dimensions in the figures). [. . . ] • Align the oven centrally in the oven housing unit/ column before securing it with the screws and spacers as shown (Fig. • Secure the oven to the unit with the screws and spacers as shown (Fig. [. . . ]