User manual WHIRLPOOL OBU 228 B INSTRUCTION FOR USE

[. . . ] This space must not be obstructed by cross rails or other structural elements. During oven installation, care must be taken to ensure that the sides are not touching the front edges of the housing or adjacent drawers and doors (see picture). No contacts • Secure the oven to the kitchen unit with screws (A) as shown. 13 54804-gb. fm5 Page 14 Thursday, April 5, 2001 6:04 PM INSTALLATION • Warning: Do not connect to the power supply before you have finished connecting the oven and the cooktop. Make sure the oven is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations. [. . . ] For reasons of safety and aesthetics, we have determined that an opening at the bottom of the door is the optimum solution. Consequently, vapour may be seen to be coming from this area on occasions (see picture). This is a normal occurrence and the bottom trim can be cleaned after removal of the door as described later in this chapter “Cleaning the oven and its accessories”. Bear in mind there may be residual steam inside the oven. Accordingly, great care should be taken when opening the oven door. Heavy weights must not be placed on the open door as this may result in damage to the cavity and hinges. Use oven gloves to remove baking trays and accessories when the oven is hot. Do not cover the bottom of the oven with aluminium foil. Do not place inflammable material in the oven risk of fire if the oven is inadvertently switched on. • The oven is equipped with air cooling system to prevent excessive temperatures of the oven front and furniture housing. Declaration of conformity These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. • The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. • The appliances are designed, built and sold in compliance with: - The safety requirements of “Low Voltage” Directive 73/23/EEC. - The protection requirements of EMC Directive 89/336/EEC. - The requirement of Directive 93/68/EEC. • • • • • Fum es e x ha u st 15 54804-gb. fm5 Page 16 Thursday, April 5, 2001 6:04 PM OVEN ACCESSORIES • Accessories supplied depend on the model (refer to the Product Description Sheet supplied separately). Drip tray The drip tray is designed to collect fat and food particles when it is positioned under the grid; it can also be used as a griddle to cook meat, chicken and fish, with or without vegetables. When using the drip tray under the grid, pour in a little water to avoid fat spatters and smoke. Baking tray For cooking biscuits, meringues and pizzas. Grid The grid can be used to grill food or as a support for baking trays, cake tins and other cooking receptacles. It can be placed on any of the runners in the oven. Catalytic panels (depending on model) The catalytic panels have a microporous coating that absorbs fat spatters. We recommend an automatic cleaning cycle after cooking particular fatty food. To clean the oven heat it to 200° C when empty and leave it switched on for about an hour. [. . . ] After the oven has been in prolonged use and when cooking on different levels (especially food with high water contents such as pizzas, stuffed vegetables, etc. . . ) condensate may form on the inside of the door seal. When the oven is cool, dry any condensate with a cloth or sponge. • • • • • • 18 54804-gb. fm5 Page 19 Thursday, April 5, 2001 6:04 PM CLEANING THE OVEN AND ITS ACCESSORIES Removing the oven door (for cleaning) 1. Lift the catches until they engage and then remove the door. Warning: While you are cleaning the oven, ensure you do not disengage the hinge retainer catches. [. . . ]