User manual WHIRLPOOL OV A11 S INSTRUCTION FOR USE

[. . . ] FRAMTID OV 3 GB ENGLISH 4 ENGLISH 4 Table of contents Safety Information Product description Control panel Daily use Cooking tables Cleaning and maintenance 4 6 7 7 9 10 What to do if . . . Technical data Installation Electrical connection Environmental concerns IKEA GUARANTEE 12 13 14 16 16 17 Safety Information Your safety and that of others are very important This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER! [. . . ] • After every use, allow the oven to cool then clean it preferably while it is still warm in order to remove built-up dirt and stains caused by food residues (e. g. • Use proper oven detergents and follow the manufacturer’s instructions to the letter. • Clean the door glass with a suitable liquid detergent. The oven door can be removed to facilitate cleaning (see MAINTENANCE). • The top heating element of the grill (see MAINTENANCE) can be lowered (some models only) to clean the roof of the oven. NOTE: during prolonged cooking of foods with a high water content (e. g. pizza, vegetables, etc. ) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. To remove the door 1. Lift the catches and push them forwards as far as they will go (Fig. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. Close the door To replace the rear lamp 1. Disconnect the oven from the power supply. A Fig. 5), replace the lamp (see note for lamp type) and screw the lamp cover back on. NOTE: Only use 25-40W/230V type E-14, T300°C incandescent lamps. Lamps are available from IKEA After Sales Service. D Fig. 4 ENGLISH 12 What to do if . . . Problem The oven does not work. Possible cause No presence of mains electrical power. The oven is not connected to the electrical supply. ‘The oven selector is turned to “0”. The oven selector is turned to “ ”. The door is locked and will not release. The electronic programmer does not work. [. . . ] Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. • Repairs caused by installation which is faulty or not according to specification. [. . . ]