User manual WHIRLPOOL OV B12 S INSTRUCTION FOR USE

[. . . ] FRAMTID OV5 ENGLISH 4 ENGLISH 4 Safety information Product description Control panel Daily use Cooking tables Cleaning and maintenance Table of contents Your safety and that of others are very important. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER! [. . . ] The oven door can be removed to facilitate cleaning (see MAINTENANCE). • The top heating element of the grill (see MAINTENANCE) can be lowered (some models only) to clean the roof of the oven. NOTE: during prolonged cooking of foods with a high water content (e. g. pizza, vegetables, etc. ) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. Accessories • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. • Food residues can be easily removed using a brush or sponge. Cleaning the rear wall and catalytic side panels of the oven (if present): IMPORTANT: do not use corrosive or i abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties. • Operate the oven empty with the fan assisted function at 200°C for about one hour. • Next, leave the appliance to cool down before removing any food residue with a sponge. -- Ensure the oven is cold before carrying out the following operations. -- Disconnect the oven from the power supply. To remove the door 1. Open the door fully. 2. Lift the catches and push them forwards as far as they will go (Fig. 1 ENGLISH 12 3. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. 2, 3, 4). To refit the door 1. Insert the hinges in their seats. 4. Close the door To replace the rear lamp 1. Disconnect the oven from the power supply. A Fig. 5), replace the lamp (see note for lamp type) and screw the lamp cover back on. 3. Reconnect the oven to the power supply. NOTE: Only use 25-40W/230V type E-14, T300°C incandescent lamps. Lamps are available from IKEA After Sales Service. D Fig. 4 ENGLISH 13 What to do if . . . Problem The oven does not work. Possible cause No presence of mains electrical power. [. . . ] Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. • Repairs caused by installation which is faulty or not according to specification. [. . . ]