User manual WHIRLPOOL OV B41 B INSTALLATION

[. . . ] Do not touch the heating elements in the oven. • This oven is designed solely for use as a home appliance for cooking food. The manufacturer assumes no responsibility for damage caused by improper or incorrect use. • Any repairs or servicing must be carried out exclusively by a qualified technician. [. . . ] • Use oven gloves to remove pans and accessories, when the oven is hot. • If alcoholic beverages are added when roasting or cooking cakes and sweets (for example, rum, cognac, wine, etc. ) remember that alcohol evaporates at high temperatures. It may happen that vapours released by the alcohol can catch fire when they are in contact with the electric heating element. • Do not heat sealed containers in the oven (except for packages specifically designed for this purpose; see the manufacturer’s instructions). The pressure that develops inside the packaging might cause it to explode, damaging the oven. • Do not use containers made of synthetic material for cooking (except for packages specifically designed for this purpose; see the manufacturer’s instructions). • Keep an eye on the oven if you are using a lot of fat or oil. Oil and fat can overheat and catch fire!• Never pull out fully loaded shelves. Use extreme caution. BEFORE USING THE OVEN • Remove the accessories from the oven and heat it 200°C for about an hour to eliminate the smell of the protective grease and insulating materials. Keep the window open during this operation. • Do not use corrosive products, hard sponges or rough cloths. Clean the aluminium surfaces with a dry cloth. Self-cleaning catalytic side panels and rear cavity (if provided) - Cleaning cycle • Heat the oven to 200° C when empty and maintain this temperature for about an hour. • At the end of the cycle and when the oven has cooled, use a damp sponge to remove any food residues. • Never clean the self-cleaning catalytic panels and rear cavity with abrasive products, rough brushes, pan scourers, or oven cleaner sprays, as they will lose their automatic cleaning properties. Accessories • Soak the accessories in water with washing up detergent immediately after use. Food residues can be easily removed using a brush or sponge. 16 61056209. book Page 17 Friday, March 21, 2008 6:39 PM Attention: When carrying out the following operations it is advisable to wear protective gloves. These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. Lift the two catches and push them forwards as far as they go (see fig. Remove the door by closing it partially and pulling it upwards (see fig. Insert the hinges into their grooves and lower the door fully. Attention: These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. 1 2 3 To lower the grill heating element (certain models only) Do not attempt to clean the oven until it is cool. • Pull (4) the grill heating element slightly forward and lower it (5). 4 5 17 61056209. book Page 18 Friday, March 21, 2008 6:39 PM Changing the rear oven lamp bulb (if provided): 1. [. . . ] Reposition the lamp cover and press it against the oven wall until it clicks correctly into place. Reconnect the oven to the electrical supply. Note: Use only 20 W/12 V, G4 type, T300°C bulbs, available from After Sales Service. Important: Do not use the oven until the lamp cover has been repositioned. 3 4 18 61056209. book Page 19 Friday, March 21, 2008 6:39 PM TROUBLESHOOTING GUIDE Oven not working: • Check for the presence of mains electrical power and if the oven is connected to the electrical supply. [. . . ]