User manual WHIRLPOOL OV G10 S INSTRUCTION FOR USE

[. . . ] GÖRLIG GB ENGLISH 4 ENGLISH 4 Safety Information Your safety and that of others are very important. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms: DANGER! [. . . ] -- Only clean the oven when it is cool to the touch. -- Disconnect the appliance from the power supply. Oven exterior IMPORTANT: do not use corrosive or i abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Oven interior IMPORTANT: do not use abrasive i sponges or metallic scrapers or scourers. Over time, these can ruin enamelled surfaces and the oven door glass. • After every use, allow the oven to cool then clean it preferably while it is still warm in order to remove built-up dirt and stains caused by food residues (e. g. • Use proper oven detergents and follow the manufacturer’s instructions to the letter. • Clean the door glass with a suitable liquid detergent. The oven door can be removed to facilitate cleaning (see MAINTENANCE). Inner glass is smooth to facilitate cleaning. NOTE: during prolonged cooking of foods with a high water content (e. g. pizza, vegetables, etc. ) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. Accessories • Soak the accessories in water with washing up detergent immediately after use, handling them with oven gloves if still hot. • Food residues can be easily removed using a brush or sponge. -- Ensure the oven is cold before carrying out the following operations. -- Disconnect the oven from the power supply. To remove the door 1. Open the door fully. 2. Lift the catches and push them forwards as far as they will go (Fig. 1 ENGLISH 14 3. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. [. . . ] Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. • Repairs caused by installation which is faulty or not according to specification. [. . . ]