User manual WHIRLPOOL PCB260 A S PRODUCT FICHE

[. . . ] After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician, according to the manufacturer’s instructions and local safety regulations. [. . . ] The Manufacturer declines any liability if the above advice and precautions are not respected 15 63702035GB. fm Page 16 Friday, February 18, 2011 10:32 AM HOW TO OPERATE THE REFRIGERATOR COMPARTMENT Switching on the appliance Starting up the appliance The appliance features internal controls. When the appliance is connected to the mains, the inside light switches on each time the door is opened. The thermostat, located inside the refrigerator compartment, is used to adjust the temperature of both the refrigerator compartment and low temperature compartment (if fitted). Appliance temperature adjustment: Temperature setting: The thermostat is used to automatically adjust the internal temperature of the refrigerator compartment and the or compartment. The thermostat knob can be turned from position1 to 7 (coldest setting) to make the internal temperature colder. When set to O the appliance is switched off. To store food for a short period of time, set the thermostat between 1 (Min) and 3 (Med). To store food for long periods of time in the compartment, set the thermostat to 3 or 4. Note: The ambient air temperature, frequency of door opening and the position of the appliance can affect internal temperatures. These factors must be taken into account when setting the thermostat. How to use the refrigerator compartment Position the food as illustrated in the figure. Cheese Notes: • The space between the shelves and the rear wall of the refrigerator compartment must be unobstructed to allow circulation of air. • Do not place food in direct contact with the rear wall of the refrigerator compartment. Defrosting of the refrigerator compartment is completely automatic. Droplets of water on the rear wall of the refrigerator compartment indicate that the periodic automatic defrost cycle is in progress. The defrost water is automatically routed to a drain outlet and into a container from which it evaporates. Defrosting the freezer compartment Defrost the freezer compartment once or twice a year or when the ice formation is excessive. The amount of ice which forms and the rate at which it accumulates will depends on room temperature and humidity, and on the frequency with which the door is opened. Ice formation is concentrated at the top of the compartment and does not affect the efficiency of the appliance. If possible, defrost the freezer when it is nearly empty. • Remove the food from the freezer, wrap in newspaper and group together in a cool place or in a portable cooler. • Leave the door open to allow the frost to melt. • Clean the interior with a sponge soaked in warm water and/or neutral detergent. • Rinse the interior and dry thoroughly. [. . . ] Is the plug properly inserted in the socket?Temperature inside the compartments is not low enough. Is the appliance installed near a heat source?Are the air circulation grilles blocked? [. . . ]