User manual WHIRLPOOL PCTOC141161F PROGRAM CHART

[. . . ] If in doubt, contact the After Sales Service. 1 4 ACCESSORY Child guard AMH 122 This accessory can be obtained from the After Sales Service under code number 4819 310 18436 or from your dealer under reference number 017124. Operation of cooking zones The cooktop control knobs are on the control panel on the oven. • Set the knob to one of position 1-6, which correspond to different temperatures. • To switch off the cooking zones, set the knob to position “0”. Important: To avoid permanently damaging the glass-ceramic top, do not use: - Pots with bottoms that are not perfectly flat - Metal pots with enamelled bottom. Any aesthetic defects (scratches, marks etc. ) must be reported at the time of installation. Care and maintenance Important: never clean the appliance with high pressure water or steam cleaning equipment. [. . . ] If possible, keep the pot covered when cooking. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. Should the hob become cracked or broken, do not use it and call the After Sales Service immediately. If the hob incorporates halogen cooking elements, do not stare at them. The hob is designed for use as a domestic food cooker only. The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls. Do not expose the hob to atmospheric agents. Any repairs or adjustments must be carried out exclusively by an authorised technician. Avoid touching the hob with wet hands or using it when barefoot. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. • Before connecting the oven (or box) to the power supply, make sure that the hob is among the ones listed in the hob/ oven pairing product sheet provided. • Connect the connectors of the hob (G) to the connectors of the oven (F) matching the colours and alignment of the housing guides visible on the top of the connectors. • Then make the connection by pushing the connectors all the way in, making sure that the tongue clicks into place. • Unscrew the nut of the ground screw (H) (fig. 4) on the top covering of the oven and insert the yellow/green ground cable, leaving the washer in place. Screw the nut back onto the screw and tighten it as far as it will go. Important: if the connection and colour coding of the hob terminals do not comply with the data given on the hob/oven pairing product sheet located on the top of the oven, please request the adapter kit code AMC 873, available from After Sales Service. Fig. 4 Preparing the housing unit • Cut the worktop to fit before installing the appliance. Carefully remove any shavings or sawdust that could prevent the appliance from running properly. Attention: to install the cooktop on other surfaces than wood (marble, plastic, ceramic, marble, stone, etc. ) remember to ask After Sales Service for the fixing plates (fig. • The hob must be fitted in a worktop with a minimum thickness of 20 mm and a maximum of 50 mm. [. . . ] Any other use (such as heating a room) is improper and dangerous. This hob has been designed, constructed and marketed in compliance with: - safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments); - protection requirements of EEC Directive “EMC” 2004/108; - requirements of EEC Directive 93/68. Glass-ceramic hob Important: remove any protective film before installing the hob. Make sure that that the opening in the worktop for the hob is cut according to the dimensions given in the drawing, paying attention to the tolerance range. The hob should not be forced into the worktop. [. . . ]