User manual WHIRLPOOL PCTOC141161NE PROGRAM CHART

[. . . ] Insert the cook hob into the pre-prepared hole ensuring that the clips (A) lodge into the bracket slots provided (C Fig. 4 B) If the worktop is made of marble or other materials (plastic compounds, ceramics, stone, etc. ), the hob must be fitted by means of brackets code 4819 310 18528. (to be ordered from After-Sales Service if not provided). • • • Fit the hob into the worktop. [. . . ] Attention: the power supply cable must be long enough to allow the cooktop to be removed from the worktop and must be positioned so as to avoid damage or overheating caused by contact with the base. Connecting to the terminal board Note: the yellow/green earth wire must be connected to the terminal with the symbol and must be longer than the other wires. 70 mm of the cable sheath from the power supply cable (B). Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as indicated in the connection diagram placed close to the terminal block itself. • Secure the power supply cable (B) by means of the cable clamp. • Close the terminal board with the cover (A) securing it with the screw provided. • After the electrical connection, fit the hob from the top and hook it to the support springs, according to the illustration. 14 ENERGY SAVING TIPS • • • • • Use pots and pans whose bottom diameter is equal to that of the cooking zone or slightly larger. If possible, keep pot lids on when cooking. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. NO! SAFEGUARDING THE ENVIRONMENT 1. Packing • The packaging material can be 100% recycled, as confirmed by the recycling symbol ( ). Use pots whose base diameter is the same as that of the hotplate/cooking zone. To avoid permanently damaging the glass ceramic cooktop, do not use: - pots with bottoms that are not perfectly flat; - Metal pots with enamelled bottom. Do not use the cooktop as a work surface or a support surface. Do not leave the appliance unattended when frying food -risk of fire. If the glass ceramic surface should break or crack due to violent impact (falling objects, etc. ) do not use it and call the After-Sales Service immediately. Do not place food wrapped in aluminium foil, plastic containers or cloths on the hot cooking zones. Do not drag pans across the glass-ceramic surface - risk of scratches. Avoid spilling sugar and similar substances on the cooktop. If necessary, clean the cooktop immediately following the care and maintenance instructions in this handbook. If the hob is fitted with halogen lamps, do not stare at the bulbs directly. • • • • • • • • HOB ACCESSORIES Child guard accessory AMH 122 This accessory can be obtained from the After-Sales Service under Part N° 4819 310 18436. 16 CARE AND MAINTENANCE OF THE GLASSCERAMIC HOB Clean the cooktop, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier. [. . . ] If a cooking zone has been selected and an “F” or an “ER” appear on the display followed by a number, contact the After Sales Service and inform them. - With the exception of the message “F03” or “ER03” that identifies the incorrect cleaning of the controls area. - To solve the problem follow the instruction in the ICleaning and maintenance of the glass-ceramic hobI paragraph. If the hob does not work following intensive use, the hob internal temperature is too high. [. . . ]