User manual WHIRLPOOL PCTOC240060F INSTRUCTION FOR USE

[. . . ] Please observe the following instructions: - The appliance must be disconnected from the power supply before carrying out any installation work. - Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer’s instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. - Regulations require that the appliance is earthed. [. . . ] Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B). Close the cover (C) and screw it on the terminal block. GB10 INSTALLATION AND FIXING IMPORTANT: the installer is responsible for any damage or injury resulting from incorrect installation. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. For cut-out dimensions, see the figure below. Dimensions in mm 580 C B 510 +1 0 Fig.  2 483 553 min. 8 +2 0 490 560 A For flush mounted installation or setting into a marble worktop, contact the After-sales Service for the installation kit and necessary instructions. • 4812 310 19277 Installation kit for marble worktop; • 4801 211 00112 Installation kit for flush fitted worktop. To guarantee correct operation, the appliance must be installed on a perfectly flat surface. If necessary, cut the kitchen unit and worktop to fit before installing the hob. Clean the cutout of any remaining dust that could compromise appliance operation. If a column unit is installed adjacent to the hob, leave a distance of at least 100 mm from the edge of the hob. Fig.  3 ASSEMBLY 1. Position the clips (A) in the spaces provided on the hob trim (Fig.  3) if not already positioned. Measure the centre point of the vertical sides of the cut-out (Fig. Fit the brackets (C) in the centre of the vertical sides, aligning the upper edge of the brackets so that they are flush with the worktop surface (Fig.  2). Fix the brackets with the 4 screws supplied (B) using the holes provided. Insert the hob in the cutout, making sure the clips (A) are secured in the spaces provided (Fig.  4). Fig.  4 Undercounter oven installation • If an oven (which must be of our manufacture) is to be installed under the hob, ensure it is equipped with a cooling system and observe the distances given in the figure to the side. There must be nothing between the cooktop and the oven (cross rails, panels, brackets, etc. ). • 5 mm Fig. 1 GB11 INSTRUCTIONS FOR USE Control Panel Description The control panel is equipped with touch controls: to use them, just press the corresponding symbol (a light touch is sufficient). Cooking zone positioning Cooktop operation lamp To clean the hob, proceed as follows: 1. [. . . ] When all the knobs are set to “0” (or to the line “____”) the hob indicator light switches off. MAINTENANCE Care and maintenance Clean the hob after each use in order to avoid damaging the surface and to prevent the formation of baked-on deposits which are difficult to remove. • • Do not use steam cleaners. Before cleaning, leave the cooking zones cool down WARNING GB12 APPLIANCE DATA PLATE MODEL SERIAL NUMBER USER ADVICE Energy saving For optimum results, observe the following advice: • Use pots and pans whose bottom diameter is equal to that of the cooking zone. • Only use flat-bottomed pots and pans. [. . . ]