User manual WHIRLPOOL PFL/C 61200 PROGRAM CHART

[. . . ] Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton. Brief 30-minutes programme to refresh your laundry. Only woollens, labelled with the Woolmark and identified as machine washable. [. . . ] * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference programmes for Energy Label. *** Automatic adaptation of programme duration after detection of wash load ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. • Turn the programme selector to the desired programme and temperature. • The indication lamp next to “Start/Pause” button blinks. • The indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION Push the button of any option desired - the respective indication lamp lights up. If the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt). Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the “Prewash” option. “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without pregressing to the final spin cycle to avoid creasing and prevent colours from changing. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” lights in the preogramme sequence indication is on. The indication lamp next to the “Start/Pause” button blinks. [. . . ] The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. [. . . ]