User manual WHIRLPOOL PLANET 1400 INSTRUCTION FOR USE

[. . . ] 1. 0 If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is used in this programme. Yes 1000 1) 400 2) max. 1000 1) Handwash 30 - 40 °C Handwas 30 - 40 °C Yes Rinse & Spin Spin Short Spin Drain Spoelen & Centrifugeren Centrifugeren Kort centrifugeren Afpompen — — — — 7. 0 Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. [. . . ] Programme Duration (hours : minutes)* 2:10 2:20 2:05 1:35 1:20 0:45 1:00 0:30 0:45 0:40 START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication light next to the “Start Delay” button lights up and the countdown of the delay time begins. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start/Pause” button, the number of hours preselected can be reduced by pressing again the “Start Delay” button. To cancel the “Start Delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 seconds - the start delay time disappears from the time display. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. Any existing water is drained out before the door can be opened. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions * applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start/Pause” indication lamp is flashing. The indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. [. . . ] “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”. [. . . ]