User manual WHIRLPOOL PWA 1010 PROGRAM CHART

[. . . ] Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. Normally soiled bed linen, table linen and underwear, towels, shirts etc. Normally soiled blouses, shirts, overalls etc. [. . . ] Slightly to normally soiled overalls ans sportswear made of cotton, polyester, polyamide and blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select „Rinse Hold“ do not leave items to soak for too long. Textiles made of silk, linen, wool and viscose marked as “handwashable”. If you select „Rinse Hold“ do not leave items to soak for too long. Programme for treating delicate laundry with starch or softener. Programme for treating cotton or linen laundry with starch or softener. Programme to spin cotton or linen laundry intensively with maximum spin speed. Programme to spin delicate laundry gently with a restricted spin speed. Press the “On/Off” button again to start the “Drain” programme . Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. PREPARATION OF WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector knob to the desired programme. Turn the temperature selector knob to the desired temperature. Turn the spin speed selector knob to the desired spin speed. [. . . ] If the spin speed “ “ is selected, the final spin is cancelled, but not the intermediate spin. The programme ends with a drain cycle. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Eco” button • The duration of the wash is extended and the max temperature reduced to save up to 40% of energy compared to a normal wash but maintaining good washing result. [. . . ]