User manual WHIRLPOOL PWA 411 PROGRAM CHART

[. . . ] Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Normally soiled blouses, shirts, overalls etc. [. . . ] Curtains and delicate clothing, dresses, skirts, shirts and blouses. Refreshes briefly worn outer clothing made of cotton, artificial fibers and blends with cotton. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. Textiles made of linen, silk, wool and viscose marked as “handwashable”. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Yes Yes 1)   X00  Cotton with rewash 95°C Cotton 40 - 60 - 95°C Synthetics with prewash 60°C Synthetics 30 - 40 - 60°C Delicates 30°C Quick wash 15’ 30°C Wool Cold - 40°C Handwash 30 - 40°C Rinse & Spin Spin Gentle Spin Drain 95°C 5. 0 40 - 60 - 95°C 5. 0 – Yes Yes 1)    max. 60°C 2. 5 Yes    max. 30 - 40 - 60°C 2. 5 – Yes    max. 30°C 30°C - 40°C 30 - 40°C – – – – 1. 5 3. 0 1. 0 1. 0 5. 0 5. 0 1. 0 – – – – – – – – – Yes Yes Yes Yes – – – –      – – – – – – –  – – –    –    – max. Please avoid excessive detergent dosing. Yes = dosing required /  = optional 5019 812 10050 CONSUMPTION DATA Temperature Programme (°C) Cotton Cotton** Cotton Synthetics Synthetics Delicates Quick wash 15’ Wool Handwash 95 60 40 60 40 40 30 40 40 (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 1. 0 (l) 50* 49 55 50* 45 50 30 55 40 (kWh) 1. 70 0. 95 0. 55 0. 80 0. 45 0. 55 0. 15 0. 55 0. 40 Load Water Energy Approx. Press the “Start/Pause” button to pause the programme. Select the new programme, any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. [. . . ] * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. Add detergent and additives into the dispenser to no more than the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (if necessary) 3. [. . . ]