User manual WHIRLPOOL PWT 3516 PRODUCT FICHE

[. . . ] I = optional / Yes = dosing required 5019 612 10193 CONSUMPTION DATA Programme Cotton Cotton Cotton+Eco ** Cotton Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Handwash Temperature (°C) 95 60 60 40 60 40 40 40 30 40 40 30 Load (kg) 5. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. [. . . ] Turn the programme selector to the desired programme and temperature. The lamp next to the “Start” button flashes. The indication lamp of the predefined spin speed lights up. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. €œPrewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 20 min. €œEco” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption is achieved. “Intensive rinse” button • The amount of water is increased to ensure a more intensive rinse. €¢ This option is particularly suitable for areas with very soft water, washing baby linen and people with skin allergies. €œRinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. PROGRAMME START Open the tap and press the “Start” button. The indication lamp next to the “Start” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. €¢ Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. €œDOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. [. . . ] Open the water tap: if the indications still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. [. . . ]