User manual WHIRLPOOL PWT 3626 PRODUCT FICHE

[. . . ] Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse hold”. – Yes i i – – i 2) i i i max. Quick Wash 30 °C 3. 0 1. 0 1. 0 – – – – 6. 0 6. 0 1. 0 – – – – – – – – Yes Yes Yes – – – – i i i i – – – – – – – – – – – – – – – – – – – – – – – – i 2) i 2) i 2) i i i i i – – i – – – i i i i – – – i i i i i i – max. 1000 3) – Cold - 40 °C Wool WOLLE Handwash 30 - 40 °C HANDWÄSCHE 30 - 40°C SPÜLEN & SCHLEUDERN SCHLEUDERN SCHONSCHLEUDERN ABPUMPEN Rinse & Spin Spin Gentle Spin Drain i = optional / Yes = dosing required 5019 612 10192 CONSUMPTION DATA Programme Cotton Cotton Cotton with Eco** Cotton Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Handwash Temperature (°C) 95 60 60 40 60 40 40 40 30 40 40 30 Load (kg) 6. 0 6. 0 6. 0 6. 0 3. 0 3. 0 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 Water (l) 59* 55 55 55 54* 48 50 40 35 55 40 40 Energy (kWh) 1. 90 1. 14 1. 02 0. 70 0. 90 0. 55 0. 55 0. 45 0. 40 0. 55 0. 55 0. 40 Approx. [. . . ] *** The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. 2. Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instruction for Use, and close the lid. 3. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the lamp next to the “Start” button flashes. The indication lamp of the predefined spin speed lights up. 4. The spin speed indicated can be altered by pressing the “Variable spin” button. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Easy ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very gently. “Eco” button • With a modified temperature profile and a slightly prologned washing duration, the optimum combination of excellent washing result and even lower energy consumption is achieved. To cancel the “Start delay” . . before you press the “Start” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start” button: • Press the “Reset” button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the “Start” button. The indication lamp next to the “Start” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. • Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. [. . . ] “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. 1. Turn the programme selector to the “Off/O” position. [. . . ]