User manual WHIRLPOOL S25C FWW2 X INSTALLATION

[. . . ] The model you have purchased may differ slightly with respect to some descriptions in this manual, since this manual covers several models. Keep this manual for future consultation. [. . . ] For correct and safe operation, install and connect the appliance according to the instructions given in this manual. The appliance is set for optimum operation at specific ambient temperature ranges, according to the climatic class indicated on the data plate: Climatic class SN N ST T Amb. (°C) From 10 to 32 From 16 to 32 From 18 to 38 From 18 to 43 Amb. (°F) From 50 to 90 From 61 to 90 From 64 to 100 From 64 to 110 The appliance may not work properly if it is left for a long period at a temperature above or below the indicated range. Temperature inside the compartments may be influenced by various factors such as: position of the appliance, ambient air temperature, frequency of door opening. Install the appliance in a dry and well-ventilated place. Avoid locations in direct sunlight or near a source of heat (oven, heating, etc. ). If this cannot be avoided, install the appliance respecting the following minimum distances: Coal or paraffin stoves: 30 cm Electric and/or gas stoves: 3 cm Install and level the appliance on a floor strong enough to take its weight and in an area suitable for its size and use. To allow product handling and sufficient air circulation, leave at least 1 cm clearance at the sides, above the appliance, and between the rear panel and the wall. 25 10200176GB. fm Page 26 Monday, July 18, 2005 11:22 AM ELECTRICAL CONNECTION Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the prescriptions. Make sure that the installation and the electrical connection are carried out by a qualified technician according to the manufacturer’s instructions and local safety regulations. If your new appliance is provided with a plug with no earth wire, connect your green/yellow earth wire (A) to the earth screw located on the appliance (B) (see figure). [. . . ] Use the wrench provided to adjust the levelling bolts. Turn the levelling bolt clockwise to raise the appliance, or anti-clockwise to lower it. [. . . ]