User manual WHIRLPOOL S25C RSS3 DF INSTALLATION

[. . . ] The model you have purchased may differ slightly with respect to some descriptions in this manual, since this manual covers several models. Keep this manual for future consultation. If you sell the appliance give it to the new buyer. Disposal of packaging materials The packaging material for the protection and transport of the appliance and single components is entirely recyclable, and marked with the recycling symbol . [. . . ] (°C) From 10 to 32 From 16 to 32 From 18 to 38 From 18 to 43 Amb. (°F) From 50 to 90 From 61 to 90 From 64 to 100 From 64 to 110 The appliance may not work properly if it is left for a long period at a temperature above or below the indicated range. Temperature inside the compartments may be influenced by various factors such as: position of the appliance, ambient air temperature, frequency of door opening. Install the appliance in a dry and well-ventilated place. Avoid locations in direct sunlight or near a source of heat (oven, heating, etc. ). If this cannot be avoided, install the appliance respecting the following minimum distances: Coal or paraffin stoves: 30 cm Electric and/or gas stoves: 3 cm Install and level the appliance on a floor strong enough to take its weight and in an area suitable for its size and use. To allow product handling and sufficient air circulation, leave at least 1 cm clearance at the sides, above the appliance, and between the rear panel and the wall. 25 10200175GB. fm Page 26 Monday, July 18, 2005 11:23 AM WATER CONNECTION Disconnect the appliance from the mains power supply before starting operations. • The ice maker and water circuit must be connected to a water supply of potable and/or chemically purified water. • The water connection must be carried out in compliance with local regulations. • The appliance is supplied with a water tube, 2. 330 m long, already attached to the back of the product. • Remove the shipping tape from the gray coiled water tubing on the rear of the appliance. • Connect the transition connector (1) to the household water supply (2). • Make sure that the water tube is not twisted. • The appliance is pre-set for operation at pressures between 1. 7 and 8. 1 bar (25 and 117 PSI). • The appliance does not require any adjustment or water drain. ELECTRICAL CONNECTION Regulations require that the appliance is earthed. [. . . ] The top bolt (1) will adjust the rear wheel (if provided), and the bottom bolt (2) will adjust the front wheel. Use the wrench provided to adjust the levelling bolts. Turn the levelling bolt clockwise to raise the appliance, or anti-clockwise to lower it. [. . . ]