User manual WHIRLPOOL S29DG FWW3 DF INSTRUCTION FOR USE

[. . . ] Disposal must be carried out in accordance with local regulations for waste disposal. PRECAUTIONS AND GENERAL RECOMMENDATIONS After unpacking the appliance, check for damage and make sure that the doors shut properly. Any damage must be reported to your dealer within 24 hours after delivery of the appliance. Be careful not to damage the floors when you move the appliance (e. g. If, after removing the doors, it is necessary to move the appliance, make sure the internal components are well secured and/or remove them in order to avoid damage. [. . . ] If, after removing the doors, it is necessary to move the appliance, make sure the internal components are well secured and/or remove them in order to avoid damage. Because of the weight of the appliance, at least 2 persons are required to safely move/install it. Installation of the appliance must be carried out by a qualified technician. Wait at least 1 hour before connecting the appliance to the power supply in order to ensure the refrigerant circuit is fully efficient. Depending on the model purchased, the appliance does not contain CFCs (if the refrigerant circuit contains R134a) or HFCs (if the refrigerant circuit contains R600a - Isobutane). Isobutane is a natural gas with low environmental impact. Caution is required, however, since isobutane is flammable. Therefore, it is essential to ensure that refrigerant pipelines are not damaged. Data regarding refrigerant and insulating substances is given on the rating plate. Clean the inside of the appliance before introducing food. If your new appliance is provided with a plug with no earth wire, connect your green/yellow earth wire (A) to the earth screw located on the appliance (B) (see figure). Ensure that the voltage indicated on the appliance data plate corresponds to the mains voltage. The plug of the appliance must be easily accessible even after installation so that the appliance can be unplugged if necessary. If this is not possible, connect the appliance to the mains supply by means of a two-pole switch with minimum break distance between contacts of 3 mm, fitted at an easily accessible point. If the power supply cable plug and socket are not of the same type, replace the socket. After installation, make sure that the appliance is not standing on the power supply cable. Disconnect the appliance from the power supply by unplugging it. Do not pull the power supply cable. 26 10200175GB. fm Page 27 Monday, July 18, 2005 11:23 AM LEVELLING YOUR REFRIGERATOR The refrigerator has two front and two rear wheels at the base of the product on each side that can be adjusted (see figure A), or four wheels of which only the two front wheels can be adjusted (see figure B). If the appliance seems unsteady or you want the doors to close easier, adjust the appliance's tilt following the instructions below (depending on the model, as shown in the figures on the right). Check the installation location to be sure you have at least 1 cm clearance on all sides including the top. [. . . ] If the appliance seems unsteady or you want the doors to close easier, adjust the appliance's tilt following the instructions below (depending on the model, as shown in the figures on the right). Check the installation location to be sure you have at least 1 cm clearance on all sides including the top. Connect the appliance to the mains power supply. Move the refrigerator into its final position. [. . . ]