User manual WHIRLPOOL SHB 905 S INSTRUCTION FOR USE

[. . . ] Before disposing of it, cut its power cable off in order to render it inoperative. PRECAUTIONS AND GENERAL ADVICE x x x x Before any cleaning or maintenance operation, disconnect the cooking hob from mains power supply. In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood). Keep children away from the cooking hob when it is in use. [. . . ] This cooking hob (Class Y) has been designed to be used only for cooking. Any other use (such as heating a room) is improper and dangerous. This cooking hob has been designed, constructed and marketed in compliance with: - safety requirements of EEC Directive “Low voltage” 73/23; - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. n 54 M 54 Y N C ENERGY SAVING TIPS x x x x x x The cooking hob is equipped with hotplates having different diameters. Use pots and pans whose bottom diameter is equal to that of the hotplates, or slightly larger. Do not operate a hotplate without placing a container on it. If possible, keep the container covered when cooking. with a small amount of water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time. CARE AND MAINTENANCE Cleaning the hob Before cleaning the cooking hob, disconnect it from mains power supply and wait until it has cooled down. Make an opening in the worktop, respecting the dimensions indicated in the enclosed product description sheet. Install the cooking hob in the worktop. A a B - If the worktop is made out of marble or other materials (plastics, ceramics or stone), the cooking hob must be fixed by means of brackets , to be ordered from the After-Sales Service (code 4819 310 18528). Align the brackets with the bores and fix them with the screws. Make an opening in the worktop, respecting the dimensions indicated in the product description sheet. Install the cooking hob in the worktop. b 56 M 56 Y N C INSTALLATION Electrical connection x x x x The electrical connections must comply with local regulations. The data relevant to the voltage and power absorption are indicated on the rating plate. The earthing of this appliance is compulsory by law. The manufacturer cannot be held responsible for injury to persons or animals or damage to property arising from failure to comply with these requirements. x x x When the cooking hob is installed, provide a single-pole circuit breaker with a contact breaking distance of at least 3 mm. [. . . ] After installation, the electric parts must not be accessible. The cooking hob must be earthed and fitted with fuses adequate to the hotplate rating. For electrical connection, use an H05RR-F cable (see table in product description sheet). ELECTRICAL COOKING HOBS WITH SIDE CONTROLS Connection to terminal board 1. [. . . ]