User manual WHIRLPOOL SPA9040 INSTALLATION

[. . . ] nEVER MOVE THE APPLIANCE BY CARRYING IT AT THE WORKTOP. Lada) Inlet hose (inside the machine or already installed) Conector en Y (sólo con algunos modelos) Adaptador em Y (apenas fornecido com certos modelos) Adaptador en forma d’Y (només inclòs en determinats models) Y-adapter (only supplied for certain models) 2 - Si no se quitan los pernos de transporte, el aparato puede sufrir daños. [. . . ] - Important: tighten the locknut by turning it counterclockwise against the appliance cabinet. - If the water inlet hose is not already installed, it must be screwed to the appliance. If your washing machine has one inlet valve on the back: connect it to cold fill only. Entrada d’aigua freda Entrada d’aigua calenta Vàlvula d’entrada blava Vàlvula d’entrada vermella Entrada d’aigua freda Adaptador en forma d’Y Cold fill Hot fill - If your washing machine has two inlet valves on the back, you must connect both valves to the water supply: • either connect red inlet valve to hot fill tap and blue inlet valve to cold fill tap • or connect both inlet valves to cold water tap by using a Y-adapter. Make sure all connections are tightly fixed. Screw the inlet hose by hand to the tap and to the inlet valve and tighten the nut. Do not use any tools for fixing the inlet hose. € The appliance must not be connected to the mixing tap of an un-pressurized water heater. € Check water-tightness of connections by turning the tap completely on. € If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50084 approved type). € Check the inlet hose regularly for brittleness and cracks and replace if necessary. € The washing machine can be connected without a non-return valve. [. . . ] Overall drain hose length: 2, 50 m (in this case, the maximum height for fixation of hose end is 90 cm). do not use extension leads or multi sockets. [. . . ]