User manual WHIRLPOOL SUPER ECO 6413 PRODUCT FICHE

[. . . ] 3. 0 Slightly to normally soiled textiles made of cotton and/or synthetics. worn outer 3. 0 Shortlywith cotton. clothing made of cotton, polyester, polyamide and blends Daily load 40 °C Gemengde was Snelwas Koud - 40 °C Quick wash 30 °C — — — — — — — — Wool Cold - 40 °C Wol 1. 0 Only woollens, labelled with the Woolmark and identified as machine washable. 1. 0 Textiles made of linen, silk, wool and viscose marked as “handwashable”. This programme is 1. 0 laundry net stronglyparticularly suitable to treat delicate lingerie (use of a recommended). Handwash 40 °C Handwas 40 °C 30 °C Lingerie 30 °C Lingerie Spoelen & Centrif. Centrifugeren Kort centrifugeren Afpompen Rinse & Spin Spin Short Spin Drain — — — — 6. 0 Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start” button. “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start Delay”. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start” button. The indication light next to the “Start Delay” button flashes and the countdown of the delay time begins. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start” button, the number of hours preselected can be reduced by pressing again the “Start Delay” button. Press the “Start” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions * applicable at that time. To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. [. . . ] “Eco” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption is achieved. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the “Prewash” option. “Easy ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier. [. . . ]