User manual WHIRLPOOL SUPER ECO 7425 PROGRAM CHART

[. . . ] made of cotton and linen. blouses, 3. 0 Normally soiledor blends shirts, overalls, etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) with cotton. 1. 5 Curtains and delicate clothing, dresses, skirts, shirts and blouses. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles linen, wool and 1. 0 made of silk (keep to care label!), and approved by viscose marked as handwashable. and This programme, at 40° C, is tested The Woolmark Company for machinehandwashable wool. Normally to heavily soiled and robust white cotton laundry. cold - 60 °C cold - 60 °C cold - 60 °C cold - 60 °C cold - 40 °C cold - 30 °C cold - 60 °C 7. 0 Save energy by selecting a lower wash temperature and adding an oxygen-based bleach product, in addition to your detergent. Yes Yes Yes Yes Yes Yes Yes max. [. . . ] The child lock cannot be activated or deactivated when the programme selector is in the “Off/O” position. To activate the child lock: • Turn the programme selector to a programme position, or run a programme as usual. • Press and hold the 2 buttons marked with the key symbol simultaneously for a few seconds. A key-like symbol will shortly appear on the display to indicate that the child lock is active. Any time you try to change a programme setting with active child lock, the display will briefly show the key-like symbol. The programme setting cannot be changed anymore. The only change possible is to switch the washer off by turning the programme selector to the “Off/O” position. To deactivate the child lock, proceed in the same way as for activating it. FAILURE INDICATORS If one of the failure indicators blinks, consult the “Troubleshooting Guide” in your Instructions for Use. “Water tap closed”: no or not sufficient inlet water. “Service”: failure or malfunction of an electrical component. “Clean pump”: waste water is not pumped out. Spin speed on display blinks: unbalance during spinning. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). To reduce the water temperature, some cold water is added at the end of the main wash cycle before the water is drained. Automatic adaptation of programme duration after detection of wash load. SAVE YOUR FAVOURITE PROGRAMMES If there is a programme setting which you use frequently, the appliance offers the possibility to save one setting for each programme so that it can be used again by just pressing one button. • Select the desired programme, temperature, spin speed and option(s), press and hold the “Favourites” button for at briefly blinks least 3 seconds. The symbol on the display and then lights up - the programme setting is saved. [. . . ] Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. “DOOR OPEN” INDICATOR Before starting and after end of a programme, the indicator lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. [. . . ]