User manual WHIRLPOOL SW810 INSTALLATION

[. . . ] IMPORTANT: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Electrical connection Cleaning the hood Warning!Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood PRECAUTIONS AND GENERAL RECOMMENDATIONS IMPORTANT! • The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To ensure best use of your hood, please read these instructions carefully and keep them for future reference. [. . . ] Make sure the hood was not damaged during transport. Declaration of conformity This product has been designed, manufactured and put on the market in conformity with the following: - safety objectives of “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. • Children must be supervised so that they do not play with the appliance. Do not connect the appliance to the mains power supply until installation has been completed. Always disconnect the hood before any cleaning or maintenance, by unplugging it or turning off the main switch in the home. Do not “flambé” food under the hood. Do not leave pans unattended when frying, since the cooking oil could catch fire. Regular cleaning and maintenance is essential for correct hood operation and good performance. Regularly clean all deposits from dirty surfaces. Regularly remove and clean or change the filter. Do not use flammable materials to duct the extracted air. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Important: Ensure that air recirculation is facilitated (carefully follow the instructions given in the installation handbook) Important!If the hood does not have a carbon filter/s, it/they must be ordered and fitted before use. The hood is provided with hardware (e. g. screws and/or plugs) suitable for most walls/ceilings. However, it is necessary to contact a qualified technician to ensure suitability according to the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Very heavy product; hood handling and installation must be carried out by at least two persons. 5019 618 33087 GB LI24YA PRODUCT SHEET CONTROL PANEL 5 Light button. Press the button to switch on the lights. Press the button to select the power/speed. Keep the button pressed for 2 seconds to go to OFF status. 1 3 2 3 4 1. Grease filter Light Steam deflector Telescopic flue Warning! [. . . ] The hood can support a maximum weight of 5 kg Fig. Disconnect the hood from the power supply. Use a small screwdriver or another suitable tool to prise and remove the lighting unit (Fig. 1). - G4 halogen lamps, taking care not to touch them with hands. [. . . ]