User manual WHIRLPOOL TC 2220/WH INSTRUCTION FOR USE

[. . . ] The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply socket. Do not pull the power supply cable in order to unplug the appliance. The electrical components must not be accessible to the user after installation. Do not touch the appliance with any wet part of the body and do not operate it when barefoot. [. . . ] € This appliance is not suitable for outdoor use. WARNING: when the hob is in use, accessible parts of the hood may become hot. Installation and connection After unpacking the appliance, check for any transport damage. In the event of problems, contact the After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. Preparing for installation WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people. The minimum distance between the hob and the bottom part of the hood must not be less than 65 cm for burning gas or other fuels and 50cm for electric cookers. Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. Electrical connection Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information can be found on the inside of the hood, under the grease filter. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. To clean the grease filter The metal grease filter has an unlimited life and must be washed once a month by hand or dishwasher at low temperature and with a short cycle. With cleaning in a dishwasher the grease filter may become dull; this does not effect its filtering capacity. Disconnect the hood from the electric power supply. 2 Remove the grease filters: pull the spring release handle downwards, then remove the filter. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. eNGLISH 9 Charcoal filter maintenance (if the hood is installed in recirculation mode) 1. Unplug the appliance or disconnect the power supply. Hook the carbon filter firstly to the metal tab at the back on the hood. Unlike traditional charcoal filters, this charcoal filter can be washed and reactivated. With normal hood use, the filter should be cleaned once a month. [. . . ] eNGLISH 12 Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). - By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]