User manual WHIRLPOOL TDV 65 INSTRUCTION FOR USE

[. . . ] • Before any maintenance on the dryer disconnect it from the mains supply. • Do not operate the dryer if it has been damaged during transport. • Mains cable replacement is only to be carried out by qualified technician or competent person. • After installation access to the mains plug has to be guaranteed, or the all-pole disconnection has to be possible with a switch. [. . . ] Disposing of packaging and old appliances. The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. The appliance is not intended for use by young children or infirm persons without supervision. General recommendations: The tumble dryer is intended only for drying textile material in water. Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Do not use inflammable cleansing agents. Do not use the tumble dryer if industrial chemicals have been used for cleaning. Garments treated or contaminated with flammable cleaning sprays or liquids such as petrol, cooking oil or aerosol sprays must not be put in this dryer. • Lighters must not be left in pockets. • Never use and store flammable materials nearby the dryer. Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. • Push the filter firmly back into place. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. EC Declaration of Conformity • This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 73/23/EEC Low Voltage Directive • 89/336/EEC EMC Directive • 93/68/EEC CE Marking Directive. 2. [. . . ] Fasten the door on the desired side using the 2 screws. Insert the door lock system on the opposite side and lock it securely. Fix the 2 screws above and below the door lock system. Replace the contact pin in the inside of the door (top). E F E 8 TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: • Was the correct programme selected? [. . . ]